Visko 303 Metal Cutter (12 Inches) Price in India, Specifications, Reviews & Offers. Buy online at Amazon . Compare Prices and Save!

price
Avadutha dm
Where can I get this in mumbai
Esta maquina es muy buena pero una falla que tiene es que no permite girar la prensa en los 2 angulos de 45 grados es solo en una direccin y eso es un inconveniente
Holy shit!
gold apex tool , is it 220 volt.
How.much.is the price if the makita LC1230 cold cut metal chop saw
Hm?
you said milwaukee right?
is it good to buy a metal cutting saw then attach to the abrasive cut off saw? New subscriber here ;)
Just a tip you dont need a metal cutting blade for aluminium its so soft you can just use a regular wood blade been doing it for years at work and it works great
How many. Cut in one blade ...
Bar soap helps when cutting aluminum:)
Hi, I bought one a yr or 2 ago, I don't use it much but I've been a joiner for 36yrs & Makita are hard to beat for quality & life length, most of my Makita tools are over 20yrs old n still work as new, they'll be still working when I'm dead n gone Can i ask how is/was the blade holding up? it's been a few yrs now, did it last a decent amount of time? Thanks
I've owned my makita lc1230 for 2 yrs on the same blade.i use it all the time.i bought a cheaper brand and it burnt up in 3 months
What a terrific review! Simple and to the point. Exactly what one expects to see. Great camera work, narration and use of time. Thank you. I really enjoyed watching this.
The supplied blade is for mild steel only. Makita does not advise to cut aluminium with the stock blade. A 12 inch non-ferrous dedicated blade with a one-inch arbor hole is recommended.
is it 220 volt ?
Decent saw, however one main thing lets it down. I did a heap of research before buying a cold cut saw and came to buying the Makita.Cuts are smooth and accurate but the pivoting attachment on the end of the thread that clamps the steel against the fixed gate gets jammed so when you tighten it hard you think the workpiece is clamped but it is jammed in its track and the workpiece is loose causing the blade to bite. the only way to avoid this is to use two hands to make sure it is secure which is a pain.
Which brand is most reliable and will still have parts available 10 to 15 years down the road?
Hi, As a joiner Makita is often my no'1 choice of tool, I did a small amount of metal work & I'm considering buying a metal saw, one of these Makita's, It's been a while now for you, how's the blade doing or how long did it last i should say? Thanks
Fence moves.The flaws in these cheep saws are always the same.Light castings for the base and fence.It's going to move.Look how high the threaded rods positioned on the clamp.It naturally wants to push over the fence and pull the base up.So what happens is too much downward pressure combine with a bad blade + an offset handle equals angry man.
shoulda put a square on a cut or two.
14.04.19 - 1.24 Not Milwaukee this one a Makita. How about clamping down 2 inch pipe and tube does it hold tight and not turn removing the tips of the teeth when the pipe turns.
evolution cost just over 40 bucks more. about 220 to your door
fence moves while you making it tight , u still think its accurate ?
. . .
8.40sec mark, if the angle piece fits against the back wall you should cut it on its edge, it will save your blade an cut quicker because your only cutting through single wall thickness the whole time