My printer have 2 black cartridges and one more is bigger which is pgbk..what is the different between bk and pgbk ink ? And can i use the same black ink for both of that cartridges ??
Hi and thanks for the tutorial. Do you think, is it possible to re-fill the Canon PIXMA PRO IP 100s? Thanks in advance.
The only issue is this, when the ink runs low, the printer starts to messing about and keep warning you that the ink is low and stops printing (at least, this is my experience.)
Videos from other providers suggest drilling out the ball seat with a 5/32 inch drill bit. Am I right in thinking that the plugs you supply make this unnecessary?
Hi, thanks for video, might be a silly question but why not just insert ink into the already open hole at bottom of the cartridge?
Is it a original cartridge? Why is it transparent ?
Damned British accent PLUS not talking into the mic made it hard to understand a word you said. Learned more from watching than listening.
thanks, are there no problems with the printer rejecting this cause of the computer chip that later on warns you your cartridge is empty
I drill a hole in the side and cover it with electrical tape.
Hi what about canon 570 and 571 do i have to reset the chip or not thank u
I've done a lot of cartridge refills over the years having to buy a new chip resetter for each new printer, but now I just buy refillable cartridges with auto reset chips.
That's great but if you check my video i use a regular screw to plug that hole.
will this work for my canon mg5470..it has cli 751 cartridges
Thank you so much for the video it sure is less expensive buying ink and refilling cartridges.
thanks for this! Just helped me install!
When pulling out the ball. I found that a thick pin pushed into the ball deep enough will let you pop it out. Best way to do this without pushing too hard into the ball is to heat up the pin beforehand so that it just melts into the center of the ball. If this makes sense?
got a canon mg6460, refilling it is the easy part but i cant figure out how to reset the ink levels, it wont let me print still says its low on ink
First of all - thank you so very much for this instruction. However, a quick question - I've just bought Canon Pixma MG-5750 and would love to know if I will be able to use that method for re-filling cartridges. The original set of cartridges is waaay too expensive to even consider it and the third-parties' products are sparse in Poland. So, I was thinking - refill would be optimum for me. Can I or can I not use this method? Cheers!
Why not just buy a new cartridge? Do you cut open your toothpaste tube to scrape out the dregs?
Wow whered you get those plugs they are perfect for this
think i might use a matt knife rather than just the glad for those who are not too handy
Thank you soooo much from Turkey
2020, thanks, from brazil :D
Better try this
do you have a methode for canon ts5050??
donde lopuedo comprar?
Thank you very much, misplaced paper work that came with printer and didn't know how to access cartridge chamber, duuhhhh. So simple and easily understood, good video. Thank you
Thank yOu so much! The way you do it makes so much sense.
preciso de ajuda eu recarrego catucho mais mesmo asim mostra vasios
Ou on peut avoir le chargeur électronique des cartouches merci
How many time can i refill without chip reseter
For my mg series, the ink level will show full level, after refill
https://www.youtube.com/watch?v=9RTErJL5hY0
Ricoh Mp c2051
Looking for the Best Small Business color Photocopy Printer Machines
high-quality, affordable photocopiers
Afordable Price. durable and fast machine
How to inter package in m130a
This tutorial demonstrates, re-filling a YELLOW cartridge, what about the known Canon ink issue of the "Yellow Jello"
when due to a chemical reaction, unless all the residual O.E.M. ink is purged, the liquids can congeal in the cartridge?
I was afraid my audio is wrong.. But the video is silent.
how to reset that cartridge ??????? finis the tutorial please
from where i can order this things
awesome directions. It's was the easiest video to follow!!!!
how do you get the printer to recognise that the cartridge is full with the chip?
If it leak from the bottom ,does that mean, i fill it to much?.It stop a few min later ,but i can still see through the clear plastic,and its empty
Hello, will it work on Canon PIXMA IX 6840?
Can u not just inject the ink directly into the sponge from the underside?
What ink do you recommend to get fine result
Hello i bought these cartridges and after a time when i refilled them again they are not recognised by the printer in spite of they are full with ink please if you know any solution just let me know
Do you can do a video about this cartridge went its ready, pliss. Thanks 😊😊
Hello, do you have cartridge for canon ts6150 pgi580, CLI 581?
Hi, will this product work on my Canon MG6800 inkjet printer?
Can i refill the Mbk black cartridge wint Bk black? I have problem with this ink Mbk, dont fix well in photopaper....any suggestion?
Hi
i buy the same color from OCTOPUS but not woking.
Nice video und nice procuct, but will der also this system fpr the pgi 50 and cli 581.
I´am really looking forward to them.
Thanks for an answer.
Hi
Can use original cartridge for refills.
How to reset ??
Thank you very much
In my case .. I have disposed of the orange caps ... what should I do?
Hello, in the first use the ink levels show full on the printer, but in the second refill, the level stays down with a yellow sign, how do you reset the ink levels? I thought it was automatic with the chips. Thank you!
i expend £38 for this after 3 4 photos comes green photos grrrrr
Hello I am from the Netherlands,can you tell me what kind of drill in mm size that I must use to drill a hole in the cartridges ?
Thank you
DO NOT USE POWER DRILLS THEY CAN EASILY DAMAGE THE CARTRIDGE! THEY CAN MAKE THE HOLE OVERSIZED SO THAT YOUR PLUG WILL NOT FIT TIGHTLY WHICH WILL RUIN THE CARTRIDGE!
ALSO THEY WILL DUMP ALL THE SHAVINGS FROM THE HOLE INTO THE CARTRIDGE WHICH WILL EVENTUALLY FLOW TO THE BOTTOM of the cartridge WHERE THE INK TRANSFERS OVER INTO THE SPONGE WHICH CAN SLOW DOWN THE INK TRANSFER PROCESS CAUSING THE CARTRIDGE TO EVENTUALLY MALFUNCTION.
HOW TO MAKE YOUR OWN HAND DRILL.
go find you a tree branch about 1/2 - 3/4 inch diameter after you peel off the bark if necessary, or get you a dowel rod, then cut it about 1 inch long, then drill a 5/32 hole in one end about 1/4 inch deep, then super glue your 5/32 inch drill bit into the end of the plug you have cut. now you have a very nice hand made drill device to drill holes into your cartridges VERY CAREFULLY "by hand" instead of using a power drill which can easily cause a damaged drill bit OVERSIZED hole if your not careful WHICH WILL RUIN THE CARTRDIGE IF your plug that fits into the drilled hole does not fit tightely.
YOU ONLY NEED TO DRILL INTO THE CARTRIDGE ABOUT 1/2 INCH DEPTH NO MORE. DO IT VERY CAREFULLY AND SLOWLY AND MAKE SURE YOU ALIGN THE DRILL BIT UP AS PERPENDICULAR TO THE CARTRIDGE AS YOU CAN. you want the drill bit to align up and exactly follow straight into the hole you are making.
SLOWLY TURN THE HAND DRILL/BIT CLOCKWISE AS YOU DRILL INTO THE CARTRIDGE KEEPING THE DRILL BIT AS STRAIGHT AS POSSIBLE LINING UP IN THE HOLE. AFTER YOUR ABOUT 1/2 INCH OR SO DEEP INTO THE CARTRIDGE WITH THE DRILL BIT,
[THIS IS CRITICAL] BEGIN PULLING THE BIT BACK OUT HOWEVER, KEEP ROTATING THE BIT AS YOU PULL OUT, THE SAME DIRECTION CLOCKWISE AS YOU WERE TURNING IT WHEN YOU DRILLED INTO THE CARTRIDGE, DO NOT TURN THE BIT COUNTERCLOCKWISE,
THIS WILL INSURE THAT YOU WILL REMOVE ALL THE PLASTIC PARTICLES THAT WILL STAY LODGED ONTO THE DRILL BIT ITSELF AS YOU PULL IT OUT SO THEY WILL NOT FALL INTO THE BOTTOM OF THE CARTRIDGE!
[one other thing when you are resetting the cartridge put blue tape not only over the vent hole of the cartridge as mentioned but also put it over the hole you drilled into the cartridge [or put a plug in it] as it will otherwise also cause air to flow into the cartridge which will help make the ink drip onto the cartridge setter head during the reset process]
Ugh
Exactly what I needed to understand You Are Awesome!!!! Thank you so much for investing the time and sharing with us &)
Very helpful! Thank you!
Love the video!! You are too funny!!!
What you mean expensive, I buy a set of 5 ......2 black's, 1Y, 1M, 1C for 12$ only the grey one is not included Canon Pixma IP8750. I see no difference with original Canon ink.
I LIVE IN MEXICO YOU ARE SELLING THIS PACKAGE OF INK. I WATCH YOU ON YOUTUBE
How is your experience with PC inks? I was wondering if you make prints using them still and how well they hold up over time? Awesome videos by the way
how was the PC inks compared to the OEM inks? is there a huge difference in quality and colors?
HAHAHA ... you are very funny. But u had done all the stuffs correct.
Awesome video loved it. As good as the best Ink refill videos by the pros. well done love your comedy too.
I used my hand drill to go into the ball and then pulled it out that way (with a very small bit) then hand drilled the the big hole. It’s a lot less scary.
I never thought I would be laughing at a cartridge refill video, but here I am laughing so hard. Pro tip, look for the Pro-10 on sale around Christmas. After rebate you can often get them for $150 and the cartridges are MUCH EASIER to refill. Literally reset the chip and then drip the ink onto the bottom of the cartridge and you're done. Oh, BTW also sign up for camera store email lists and other photography websites that will alert you when special deals on the Pro-100 will go on sale. One can often get the Pro-100 after rebate for all of $60-$80 so you have a cheap set of ink and spare parts if you need.
I have a set of Precision Inks and I was planning to replace just my precision ink Cyan Cartridge with a
Canon original CL-42 Cyan. Will this affect my prints drastically?
Thanks, this was a big help!
senpai what sticker can you recommend in printing and inks, dye based or pigment? please reply
Do you need to buy the OEM inks at least once so you can refill them with the Precision Inks?
Thank you! Very helpful tutorial as I just bought the printer myself.
I've heard good things about their ink.... I'm going to give them a try... Thank you!